← Blog
20 January 2025·6 min read

Flat bike tyre: why it happens and how to fix it

A flat tyre is the most common problem cyclists bring to our workshop in Pinosava. Here is everything you need to know — from the causes to prevention.

Every cyclist who rides a bit more has felt it — you are riding normally, then the bike starts behaving strangely, steers heavier, or you simply hear that typical hiss. A flat tyre. It is not dramatic, but it can ruin a planned ride and, if ignored, lead to a more expensive repair of the rim or the tyre.

At Bicikl servis Avala in Pinosava, inner tube replacement is among the three services customers ask for most — all year round. In this article we go through everything: why tyres puncture, how to recognise the type of puncture yourself, when a patch is enough and when the tube should be replaced, and how to lower the chance of it happening again.

Why tyres puncture — and it is not always a nail

The most common cause is a foreign object — a nail, glass, a thorn or a sharp stone. But some causes are not immediately visible. A 'pinch flat' or 'snake bite' happens when the rim cuts the inner tube on a hard hit against a kerb or a pothole, and it is especially common on bikes with low tyre pressure.

The third common cause is ageing. A tube that has been sitting for years loses elasticity and develops tiny cracks. If you took the bike out of the basement after a long break and the tyre goes flat within a day or two for no visible reason — the material has most likely simply worn out.

The valve can also be the culprit: a sharp edge of the valve hole or a damaged valve can cause a slow leak you do not notice straight away.

💡 Tip

Check your tyre pressure once a week. The recommended pressure is always printed on the tyre sidewall (e.g. '6–8 Bar' or '85–120 PSI'). Properly inflated tyres have three times lower risk of a pinch flat.

How to recognise the type of puncture

When you take the tube out, the shape of the hole tells you a lot. One small round hole — a foreign object. Two small holes side by side in a 'U' shape — a classic snake bite from an impact. A long linear split — most often a damaged rim tape or a sharp edge on the rim.

The location matters too: holes on the outer side of the tube come from outside (nail, glass), holes on the inner side point to a problem with the rim (bad rim tape, a sharp spoke end).

  • →One round hole — foreign object (nail, glass, thorn)
  • →Two 'U'-shaped holes — snake bite, low tyre pressure
  • →Linear split — problem with the rim or the rim tape
  • →Slow leak without a visible hole — aged material or the valve

Patch or replace the inner tube?

A small, clean hole from a foreign object — patching is a perfectly legitimate fix, especially out on the road. A modern patch kit lasts for years and there is no reason to throw away a good tube because of one hole. In the workshop we always check the condition of the whole tube before deciding.

However, if the tube is old, has several holes, or the split is longer than 5–6 mm, replacement is the better choice. Patching several holes makes a weak tube that does not hold pressure evenly. A tyre change in our workshop costs 900 RSD per wheel (labour), with a tube that will last for years.

Rear tyre on an e-bike or a bike with a hub gear

This is a category of its own. A bike with a hub motor or a Rohloff/Alfine internal gear hub has a more complicated rear wheel — cables, connectors and the motor have to be carefully disconnected and reconnected. A mistake during fitting can cause a fault that costs far more than the tyre change.

In our workshop every e-bike rear wheel is treated separately: for a tyre change on the rear wheel of a hub-motor e-bike or a rear wheel with an internal gear hub (Nexus, Alfine) we set the price on site, after an inspection, because it depends on the system. If you are not sure which type your bike is, call us before you come.

How to lower the chance of a puncture

Regular pressure checks and choosing the right tyres for your terrain can dramatically cut the number of punctures in a season. For city riding in Belgrade, tyres with a reinforced anti-puncture layer are an excellent investment — the price difference compared to standard tyres is negligible next to the savings on repairs.

A tubeless setup goes one step further — without an inner tube, small punctures seal themselves thanks to the liquid sealant. If you often ride on gravel or in Belgrade's parks, a tubeless conversion is worth considering. We cover it in a separate article.

💡 Tip

Do not ride on a flat tyre one metre more than you have to. Riding on an empty tyre damages the rim and can cost 10–20× more than replacing the inner tube.

Maintenance tips

Leave your email — we send useful tips.

No spam. Only practical bike service and maintenance advice.

NEED A SERVICE?

Diagnostics are always free. Bring your bike to Pinosava or we collect it anywhere in Belgrade — we check what it needs together and you decide what we do.

Bike repair in Belgrade — prices and bike pickup →