← Blog
12 November 2026·8 min read

Winter bike service: overhaul, tune-up, greasing and bike hygiene

Winter is the best time for a full bike service: the workshop is quiet and the bike meets spring ready to ride. What an overhaul covers, why greasing and hygiene matter more than they seem, and how often each job should be done.

When the season ends, most bikes go into a basement or garage — dirty, with a chain last lubed in August and brakes that are "still fine". Spring brings the surprise: a rusty chain, seized cables, a soft brake and bearings that creak.

That is why winter is the best time for a full service. The workshop is not busy, parts arrive in time, and on the first sunny day the bike is ready to ride. This article goes through everything a winter service covers — and what you can do yourself between two services.

If you also ride in winter, read our article on preparing a bike for winter riding and storage — here the focus is on the service itself.

Bike hygiene: the basis of everything

A dirty bike wears faster. Sand, mud and road salt form an abrasive paste that grinds the chain, cassette, chainrings and jockey wheels. The same dirt gets into cable housing and bearings and speeds up corrosion. A bike that is washed and lubed regularly lasts literally twice as long as a neglected one.

Hygiene matters for the service too: a dirty bike cannot be inspected properly — a frame crack, an oil leak from the fork or a worn pad are easy to miss under a layer of mud. That is why bikes that arrive visibly dirty are always washed first.

  • →Wash the bike with a mild detergent or bike wash, a soft brush and a gentle stream of water — never a pressure washer on bearings, drivetrain or fork, as it forces water and dirt into them.
  • →After riding in rain, mud or on salted roads, rinse the bike with clean water, dry it and lube the chain.
  • →Wipe the chain with a dry rag after every ride — thirty seconds that extend the life of the drivetrain.
  • →Keep the bike somewhere dry, not on a balcony or under a carport where moisture condenses.

Drivetrain hygiene: how and how often to lube the chain

The chain is the hardest-working and fastest-wearing part of the bike. Proper drivetrain care is the one bit of "maintenance" that is really worth doing yourself, and doing regularly.

  • →Summer, dry and dusty: dry lube (wax or PTFE based). A thin film that attracts less dust, but needs applying more often.
  • →Winter, rain and salted roads: wet lube, resistant to water and salt. It protects better against rust but collects dirt, so wipe it regularly.
  • →Lube every 150–300 km and always after a ride in the rain. The rule is "less, but more often": one drop on each link, turn the cranks backwards and after a few minutes wipe off the excess with a dry rag — extra lube only collects grit.
  • →Every 300–500 km (more often in winter) thoroughly degrease the chain, cassette and chainrings, rinse, dry and lube again.
  • →When switching from wet to dry lube, fully degrease the chain first — the two do not mix well.
  • →WD-40 and similar sprays are not chain lube: they dissolve the existing lube and do not protect.

💡 Tip

With proper care a chain lasts about 3,000–5,000 km, and a cassette 2–3 chains, about 10,000–15,000 km. The condition is replacing the chain on time, when a checker shows 0.5% stretch (11–12 speed) or 0.75% (up to 10 speed). A chain ridden to the end destroys the cassette and chainrings too — so instead of one part, the whole drivetrain gets replaced.

Full service (overhaul): what it covers

A full service is more than a "tune-up". The bike is partly or fully stripped, every assembly cleaned and inspected, worn parts replaced, and everything put back together with fresh grease and tightened to the specified torque.

  • →Free diagnostics: frame, fork, drivetrain, brakes, wheels and bearings checked, with a list of what is needed and what it costs — nothing is done without your OK.
  • →Bike wash and deep drivetrain cleaning: chain, cassette, chainrings and jockey wheels.
  • →Chain stretch and cassette wear measured, replaced if needed.
  • →Gear and brake cables and housing checked and replaced.
  • →Bearing service: hubs, bottom bracket, headset and pedals.
  • →Brakes: pads, centring, and on hydraulic brakes a bleed.
  • →Wheels: truing, spoke tension, rim and tyre condition.
  • →All bolts torqued to spec and a final test ride.

Tune-up: gears and brakes

After a new cable, chain or cassette the derailleur is always set up again from scratch: limit screws, cable tension, B-screw and indexing, with the derailleur hanger checked — a bent hanger is a common reason why gears keep drifting even after adjustment. Brakes are centred to the rim or rotor and the lever travel set, so the brake bites firmly without rubbing.

Derailleur adjustment (front or rear) costs 3,100 RSD with us, and brake adjustment 1,000 RSD (V-brake) or 1,100 RSD (mechanical disc) per brake; a rubbing disc brake gets its caliper centred for 900 RSD.

Greasing the bearings after winter

Bearings are the easiest part to forget, and winter hurts them most. Moisture and condensation while the bike stands wash out the grease, and salt and water cause corrosion. The result is a wheel that turns rough, a creaking bottom bracket or a headset that knocks under braking.

  • →Hub, bottom bracket, headset and pedal bearings — and on full-suspension bikes the pivot bearings — should be opened, cleaned, inspected and greased once a year. Best in spring, after winter.
  • →If you ride in rain and mud or wash the bike often — every 6 months.
  • →Cartridge (sealed) bearings that have play, creak or turn rough are replaced.
  • →A bearing serviced on time lasts for years. A neglected one damages its seat in the hub or frame, which is a much more expensive repair.

Cables, housing and brake fluid

Cables and housing are consumables: water and dirt get in over time, friction rises and shifting and braking get heavier — gradually, so it often goes unnoticed. Replace them once a year if you ride regularly or in the rain, or every 18–24 months if the bike is stored indoors and ridden in the dry.

On hydraulic disc brakes the bleed interval depends on the fluid. DOT fluid (SRAM, Hope, Hayes, Formula) absorbs moisture, so its boiling point drops over time — it is replaced once a year. Mineral oil (Shimano, Magura, Tektro) does not absorb water and is bled every 1–2 years, or straight away if the lever goes soft. The two fluids are never mixed.

  • →Gear cable replacement: 1,500 RSD (MTB) / 1,550 RSD (road/gravel)
  • →Brake cable replacement: 1,500 RSD per brake, with new housing 2,000 RSD
  • →Hydraulic brake bleed: 2,900 RSD per brake
  • →Internal routing through the frame and gear cable with housing: price set on site

Fork and rear shock

If the bike has suspension, it needs regular service just like a car engine: a lower service (wipers, oil in the lowers and air spring) every 50–125 hours of riding depending on the maker, and at least once a year; a full service (damper, all seals and oils) every 125–200 hours or every 1–2 years. Wipe the fork stanchions after every ride and check the air pressure once a month.

If the fork leaks, sinks or has play, do not wait for the interval — damaged stanchions cost more than all the regular services together.

What it costs and how to book

We do not sell packages — every bike gets a work order with exactly what it needs. Diagnostics are free and you know the price before we start. The most common winter-service items have a fixed price: basic wash 2,500 RSD, chain replacement 1,150 RSD, cassette replacement 1,150 RSD, hub service 2,200 RSD per wheel and wheel truing 3,050 RSD. Parts are charged separately, and the full list is on the Prices page.

Book through the website, WhatsApp or Viber. Every work order also comes with maintenance recommendations until the next service — what to do and how often, for your bike.

Maintenance tips

Leave your email — we send useful tips.

No spam. Only practical bike service and maintenance advice.

NEED A SERVICE?

Diagnostics are always free. Bring your bike to Pinosava or we collect it anywhere in Belgrade — we check what it needs together and you decide what we do.

Bike repair in Belgrade — prices and bike pickup →